Teses #concrete

Reinforced concrete beams are submitted to thermal deformations when exposed to fire. The lengths of the spans elongate, a fact that triggers the horizontal displacement of their supports, and they begin to bend sharply, resulting in their rotation. If these deformations are hindered by the support conditions of the element or by surrounding structural elements, for instance, additional efforts will act on the beams in order to modify their performance when facing the action of fire. Studies have pointed out that the effects of such efforts may be beneficial to the fire resistance of the beams; however, in the few researches focused on the experimental analysis of this issue, the restraints were admitted only in an isolated way, i.e., the beams were either submitted to axial or to rotational restraints. Their coupled effect, more representative of what occurs in reality, and the consideration of different stiffness levels imposed on the deformations, were evaluated in numerical investigations, without suitable experimental data for validating the results, though. In this PhD Thesis, the performance of concrete beams was evaluated experimentally by performing bending tests on full-scale elements under different support conditions: unrestrained, only with axial restraints and with both axial and rotational restraints. Regarding the restrained elements, two levels of axial and rotational stiffness were analyzed, 0.02 and 0.04EA/l; 1 and 2EJ/l. There were also reference tests on simply supported beams at ambient temperature to check the load-bearing capacities and failure modes. The experimental data obtained for different beam static schemes still motivated the conception of numerical models that would be representative of their behavior. With the aid of the DIANA software, which is based on the finite element and displacement methods, beam models to represent beams tested at ambient temperature and in fire conditions were created. These models were implemented considering several properties that characterize the nonlinear behavior of the materials and led to good correlations when their results were compared to those obtained in the laboratory. The main conclusion of this experimental and numerical study was that the fire resistance of RC beams always increases when any type of restraint (axial or axial plus rotational) is introduced. In addition, by fixing the rotational stiffness, the beams with higher axial stiffness level presented higher fire resistance than those with the lower level. The same was observed by fixing the axial stiffness and varying the rotational stiffness. Beams in which the combined effect of the restraints was admitted led to higher resistances than those with only axial restraint. For most of the studied situations, the increases of the resistances showed to be significant when confronted with the ones for unrestrained beams. Thus, it was confirmed that the standard simplified methods that allow the non-consideration of these effects during the fire design of the RC beams lead to conservative results. The numerical and experimental results presented herein may aid in the conception of alternative tools that allow applying restraint effects to design.

The thermal and mechanical properties of building materials are reduced at high temperatures, and the structural resistance of reinforced concrete buildings, as well. If the means of active protection are not efficient the fire will develop and the consequential increase in temperature can take an important role on the local failure of a single member or the progressive collapse of the building. The structural design must take into account the possibility of a fire happening as an accidental action during the lifetime of the building, aiming mainly at the protection of the users lives. This doctoral thesis aims to contribute to the development of the technical references in Portuguese about the fire design of reinforced concrete structures, to stimulate further researches and afterwards standard reviews related to the structural design in fire of reinforced concrete buildings. The work reviews the heat effects on the thermal and mechanical properties of the materials and the consequential impact on the structural behaviour of reinforced concrete buildings, the calculation methods available in the international technical reference for the fire design of reinforced concrete structures and presents a proposal of an optimized simplified calculation method for the members under simple bending or composed axial-moment load, considering the geometric and concrete characteristics very usual in Brazil.